Archive for Middle Georgia VW/Audi Group
  Forum Index -> H-o-H Technical

column pod install on a mkv

if anyone has some talent or knows of someone that does I need to look into getting my boost gauge installed on teh column. Please hit me up here or email

its not too hard to install.  just have to take off lower dash on drivers side and then route your power and vacum lines up to the colum.  and have to cut a small hole in the flexable trim piece on the colum to route your lines and wires up to the back of your gauge.  for power/back lighting of the gauge just tap into one of the lighting wires on the back of your light switch (use one that has power on when you turn on your lights).  for your vacum you are going to need a "T" fitting to tap into the vacum supply by the FPR (fuel pressure regulator)  then pass it through the firewall using one of the holes already there with a rubber grommet in it (punch a hole in the grommet for line)  any questions give me a call
for 7 eight  397-  nine three ate O Forum Index -> H-o-H Technical
Page 1 of 1
Create your own free forum | Buy a domain to use with your forum